Blog
Alkaline Electrolysis at 1,000 V Could Cut Costs 10-15%
- November 3, 2026
- Posted by: Clean Energy Skills
- Category: Hydrogen Energy

Estimated reading time: 6 minutes · Last updated:
Researchers at Finland's LUT University have run a series-connected alkaline electrolysis system at 1,000 V, a voltage the team describes as a record. A higher voltage lets the system draw less current. That trims electrical losses and the cost of power supplies and power electronics. Those parts make up roughly a quarter of a hydrogen plant's investment bill. The researchers estimate that halving them could lower total system investment by around 10% to 15%. Industrial alkaline electrolysers typically run at roughly 200–400 V. Three other developments arrived alongside it: a binding green ammonia deal between Jera and AM Green, a European Commission platform offering up to €4.5 billion in guarantees for the Mediterranean, and a University of Trieste study pricing hydrogen imports from Oman.
Key takeaways
- Voltage milestone: LUT University operated a series-connected alkaline electrolysis system at 1,000 V, against the roughly 200–400 V typical of industrial units, using ABB power electronics and Stargate Hydrogen stacks.
- Cost lever: Power supply and power electronics are about one-quarter of a hydrogen plant's investment cost, and the LUT researchers estimate halving them would cut total system investment by around 10% to 15%.
- Ammonia for ships: Jera will buy about 70,000 metric tons of green ammonia a year for five years from AM Green's planned Kakinada plant in Andhra Pradesh, which is expected to start in 2028-2029.
- Imports versus local: A University of Trieste study puts the cost of hydrogen imported from Oman at €7.84/kg against €10.22/kg for Italian production, though domestic output emits less over its lifecycle.
Table of contents
- Key takeaways
- Why 1,000 V Lowers the Cost of Alkaline Electrolysis
- Jera and AM Green Commit to Indian Ammonia for Car Carriers
- How the EU's T-MED Platform Feeds Egypt's Hydrogen Base
- Is Hydrogen From Oman Cheaper Than Making It in Italy?
- What could speed or slow these projects
- What to be careful about
- Frequently asked questions
Why 1,000 V Lowers the Cost of Alkaline Electrolysis
An electrolyser uses electricity to split water into hydrogen and oxygen. At a fixed power level, raising the operating voltage lowers the current. Less current means less energy wasted in cables and conversion equipment. The LUT University team wired stacks in series to reach 1,000 V. That is about 2.5 to 5 times the 200–400 V band where industrial alkaline units usually sit.
The financial lever is the equipment around the stacks, not the stacks themselves. LUT University puts power supply and power electronics at approximately one-quarter of a plant's investment cost. Halving that slice would save about 12.5% of the total, which sits inside LUT's 10% to 15% estimate. That figure is a projection, not a result measured at a commercial plant.
ABB supplied the power electronics, and the Estonian company Stargate Hydrogen provided the electrolyser stacks. The next phase covers system design, modelling and minimising stray currents. Stray currents are electricity that leaks along unintended paths through a system. Solving that is the step the team names before high-voltage electrolysis can scale.
Jera and AM Green Commit to Indian Ammonia for Car Carriers
Japan's Jera and India's AM Green announced a binding agreement on 27 October 2026. It covers about 70,000 metric tons of green ammonia a year over five years, or roughly 350,000 tonnes in total. The fuel will come from AM Green's planned facility in Kakinada, Andhra Pradesh. Operations there are expected to begin in 2028-2029.
Cargoes will go to terminals beside the Hekinan thermal power station in Aichi Prefecture, a Jera site, where the ammonia will be received, stored and distributed. Its main use will be fuelling ammonia-powered car carriers. Jera is working with Kawasaki Kisen Kaisha and Nippon Yusen Kabushiki Kaisha on bunkering infrastructure, the equipment that loads fuel onto ships.
A separate deal brings seven Japanese companies together on a joint ammonia supply chain across the Chubu region. They also plan four car carriers that burn ammonia. The ships and a purpose-built bunkering vessel are due in 2030. The Kakinada plant is still planned, so every tonne in the contract depends on that construction schedule holding.
How the EU's T-MED Platform Feeds Egypt's Hydrogen Base
The European Commission has launched the T-MED Investment Platform. Its purpose is to draw large-scale money into renewable energy and clean technology around the Mediterranean. EU backing includes up to €4.5 billion in guarantee capacity. A guarantee absorbs part of the potential losses on a loan or investment, which makes projects easier to finance.
Among the projects chosen are the Niat and Rasgha Wind Projects in Egypt. Together they add 500 MW of onshore wind capacity on the Gulf of Suez and use European wind technology. The Commission links them to Egypt's future hydrogen output. The connection is indirect, however. The turbines supply the renewable power that electrolysis would later need, and they produce no hydrogen themselves. The €4.5 billion is also a ceiling on guarantees rather than money already committed.
Is Hydrogen From Oman Cheaper Than Making It in Italy?
Six researchers at the University of Trieste modelled two supply chains in the International Journal of Hydrogen Energy. Both rely on proton exchange membrane water electrolysis (PEMWE), a design that splits water across a solid polymer membrane. The study counts every stage: renewable power generation, liquefaction, storage, transport and regasification.
The levelized cost of hydrogen, the average cost per kilogram over a project's life, came to €7.84/kg for Omani imports and €10.22/kg for Italian production. Imports therefore come out about €2.38/kg, or roughly 23%, cheaper. The carbon result runs the other way. Domestic hydrogen carries 2.26 kg of CO₂ equivalent per kilogram, against 2.62 kg for imports.
Electrolysis dominates both sides of the ledger. Of the total cost, 74.4% traces back to it, and so does as much as 81% of the carbon footprint. Shipping adds around 10% to the final price of imported hydrogen. The University of Trieste group points to ports and the North Adriatic Hydrogen Valley as places where domestic and imported supply could meet. The study covers PEM systems, not alkaline ones. Even so, it shows why savings on electrolyser hardware, such as those LUT is pursuing, matter so much.
| Development | Parties | Key figure | Timing |
|---|---|---|---|
| 1,000 V alkaline electrolysis | LUT University, ABB, Stargate Hydrogen | 10-15% lower system investment (estimate) | Scale-up research next |
| Green ammonia supply deal | Jera, AM Green | About 70,000 t a year for five years | Plant start 2028-2029 |
| Ammonia car carriers | Seven Japanese companies | Four vessels plus a bunkering ship | Completion 2030 |
| T-MED Investment Platform | European Commission | Up to €4.5 billion in guarantees; 500 MW wind in Egypt | Launched |
| Italy vs Oman hydrogen study | University of Trieste | €7.84/kg imported vs €10.22/kg domestic | Published |
What could speed or slow these projects
The case for
- Running at higher voltage targets power supply and power electronics, about a quarter of plant investment, without requiring new stack chemistry.
- A binding five-year offtake gives AM Green's Kakinada plant a named buyer before operations begin.
- Up to €4.5 billion in EU guarantee capacity lowers the financing risk for Mediterranean renewables such as the 500 MW Niat and Rasgha projects.
The case against
- LUT's 10-15% saving is a modelled estimate, and stray currents still have to be minimised before high-voltage systems can scale.
- The Kakinada facility is still planned, so supply to Jera depends on a 2028-2029 start.
- The Trieste study shows domestic Italian hydrogen costing €10.22/kg, which leaves a gap of about €2.38/kg against imports despite its lower emissions.
What to be careful about
- Stray currents may grow harder to manage at 1,000 V and above, which could erode the cost savings LUT has projected.
- Delays at Kakinada would push back ammonia deliveries to Hekinan and the bunkering plans of Kawasaki Kisen Kaisha and Nippon Yusen Kabushiki Kaisha.
- The University of Trieste cost comparison rests on modelled supply chains, so real shipping or liquefaction costs could shift the gap between Oman and Italy.
The bottom line
The LUT result tackles hydrogen costs at the equipment that surrounds the electrolyser stack. Most efforts focus on the stack itself. If running at 1,000 V can halve the cost of power supply and power electronics, the researchers' 10% to 15% saving follows from simple arithmetic. Stray currents remain the open engineering question. The Trieste study shows what is at stake, because electrolysis makes up 74.4% of hydrogen's cost there. Meanwhile, the Jera and AM Green deal and the EU's T-MED platform show money moving towards supply chains that do not exist yet. Kakinada still has to be built, and Egypt's 500 MW of wind still has to generate power before it can feed any electrolyser.
What to watch
- Watch for LUT University's results on system design, modelling and stray-current control, the step it needs before scaling high-voltage electrolysis; no date has been set.
- Watch whether AM Green's Kakinada ammonia plant starts operating in the 2028-2029 window, which determines when the Jera supply deal begins.
- Watch for completion of the four ammonia-fuelled car carriers and the dedicated bunkering ship, which the seven Japanese companies have scheduled for 2030.
Frequently asked questions
What voltage do industrial alkaline electrolysers normally use?
Industrial alkaline electrolysers usually operate at roughly 200–400 V. LUT University's series-connected system reached 1,000 V, about 2.5 to 5 times that range.
How much does hydrogen imported from Oman to Italy cost?
The University of Trieste study estimates €7.84/kg for hydrogen imported from Oman, compared with €10.22/kg for production in Italy. Of that delivered import price, roughly a tenth comes from carrying the hydrogen by sea.
When will AM Green start supplying green ammonia to Jera?
Supply depends on AM Green's planned Kakinada facility in Andhra Pradesh, which is expected to start operations in 2028-2029. The contract then runs for five years at about 70,000 metric tons a year.
Related reading